Polaroid SprintScan 45 User Manual

The scanner and accessoriesa Power/Ready indicator lightsb Film carrier slotc Carrier access door2 Setup and use2-1

2-2a Air intake d Power connectorb SCSI ID switch e SCSI connectors (25, 50)c Power switcha 4x5 carrier e Magnets for c and db Four-slide film carrier

Positioning the scannerPlace the scanner on a flat, stable surface, free of vibration.Leave at least 2 inches (50mm) of space around all sides andthe

2-4The SprintScan 45 scanner is unterminated. If it is the lastdevice in the chain, add a terminator. See the illustrations onpages 2-9–2-10. Powerboo

Setup and use 2-5SCSI ID numbersWARNING: TO PREVENT DAMAGE TO YOUR HARDWAREAND SOFTWARE, READ THIS SECTION BEFORE TURNINGON YOUR SYSTEM. Each device o

2-6Installing a SCSI adapter in a PCIf you are using a PC-compatible computer, you must have aSCSI host adapter installed in your computer for connect

Setup and use 2-7The second port (25-pin) can be used to connect another SCSIdevice to the chain, using another SCSI cable. 3 Terminate the signal at

Diagrams of various SCSI configurationsThe following diagrams illustrate different configurations.Find the appropriate configuration for your hardware

Place the scanner at the end of the chain and use the termina-tor provided. Do not add any additional terminators. If oneexternal device has an intern

Using the film carr i e r sThe four-slide 1 With the text facing up and the hinge at the top, open the film carrier carrier flat as shown (picture 5)

iQuick Scanning Guide iii1 IntroductionSystem requirements 1-3Technical Support 1-4Registration card 1-4Unpacking 1-52 Setup and useThe scanner and ac

2 Open the carrier flat. Insert a 4x5 chrome or negative so thatthe left edge is against the positioning pins (picture 8).Position the film so the ima

1 Open the 4x5 carrier as described previously.2 Locate the appropriate adapter for your image. One isdesigned for 2 1/4 x 2 3/4 in. images, and one i

1 Open the 4x5 carrier as described previously. 2 Locate the single-35mm adapter. Note: You can use a nega-tive, or a mounted or unmounted slide.3 Ori

I n s e r ting the carrier into the scanner1 Open the carrier access door (picture 17). 2 Insert the carrier gently and firmly into the carrier slot a

M a i n t e n a n c eKeep the carrier access door closed when the scanner is not inuse, to protect it from dust. Cleaning the cabinet Clean with a mil

Tro u b l e s h o o t i n gWhen the scanner is powered up, the POWER indicator shouldcome on and the READY indicator should flash. A few secondslater,

Limited One Year Equipment Wa rr a n t yPolaroid Corporation warrants your Sprintscan 45 scannerequipment against defects in manufacture for a period

3-4MassachusettsPolaroid CorporationTel.: Toll free 1-800-432-5355AustraliaPolaroid Australia Pty Ltd13–15 Lyonpark RoadPO Box 163North Ryde, NSW 2113

Care and maintenance 3-5JapanNippon Polaroid Kabushiki KaishaMori Building, No. 302-2 Toranomon 3-chomeMinato-kuTokyo (105)Tel.: 81-3-3438-8811Toll f

3-6Radio and television interf e re n c eFCC Notice (U.S.A.) Note: This equipment (Model: CS-4500) has been tested and found to comply with the limits

ii3 Care and maintenanceMaintenance 3-1Troubleshooting 3-2Limited One Year Equipment Warranty 3-3Service 3-3Polaroid Offices and Service Centers 3-4Ra

Media capability 35mm to 4x5 in. format, positive and nagative, mounted andunmounted transparenciesMaximum scan time 26ms/RGB lineActual resolution Mi

Power 40WAccessories Film holders: 4 x 5 in. (10.2 x 12.7cm)2.4 x 2.8 in. (6x7cm)2.4 x 2.8 in. (6 x 6cm)35mm four-at-once35mm single mountDimensions (

I-1E8-bit gray mode, 1-1FFan, 2-2FCC notice, 3-6Film carrier slot, 2-1Film carriers, 1-5, 2-2, for 4x5 film, 1-5, 2-2, 2-10-2-11four-slide film carrie

PPass-through terminator, 1-5, 2-7PC system requirements, 1-3Plug-in module, 1-1Polaroid Offices and Service Centers, 3-4–3-5Positioning the scanner,

Use this guide as a quick reference for scanning. For details,see the pages indicated. See page:2-6 1 Install a SCSI host adapter card in your compute

The Polaroid SprintScan 45 multi-format film scanner allowsyou to capture and convert film images into electronic filesthat you can edit and incorpora

Scanning modesThe digitized images can contain up to 4000 dpi (dots perinch) of image information. Color is achieved with a tri-colorCCD in combinatio

System re q u i re m e n t sMacintosh systems •A Macintosh Quadra or PowerPC computer.•System 7.1 or higher is required; System 7.5 is recommended.•16

1-4Technical SupportHardware support If you need additional help with your Polaroid SprintScan 45 scanner, call us toll-free from within the continent

U n p a c k i n gThe SprintScan 45 scanner is a precision instrument. Handle itas carefully as you do your hard drive. Save the protectivepacking mate